WING LOCKER
V-22
The cutout in the Top Skin, installation of the hinge
32.
Wing Looker door 6SV4-5
REFERENCE:
6V7, 6SV4
LAYOUT:
Position the Wing Locker Door 6V7-8 on the Rear Top Skin between Rear Rib #6
and #7, the sides are parallel with the rib rivet lines. Trace around the door.
DZUS FASTENERS:
The wing locker door is held closed with Dzus Fasteners along the sides
and the aft edge. Before cutting out the opening know how the Dzus Spring S5A-225 will be
attached. The size of the opening is determined by the method used to install the Spring.
CUTOUT:
Approximately 45mm smaller than the Wing Locker door, the overhang is to rivet
the Dzus Spring in the Skin.
33.
Wing Locker Channel 6VS4-4
NOTE:
The Channel will slice through the third lightening hole of the outboard Rear Rib #7
POSITION:
The flange point back and rivets to the Top Skin
BOTTOM FLANGE:
Riveted length of L angle.
L ANGLE:
Between the Channel and the Rib.
34.
Piano Hinge length
POSITION
: Instead of sliding the hinge inbetween the Rear Skin and the Nose Skin the Hinge
can be positioned underneath the Spar Extrusion. Pull the pin out, reverse one of the sections,
and insert the pin. Trim both end of the hinge
LENGTH
: The length of the hinge is the same as the width of the wing locker.
RIVET
: A5
35.
Dzus
SUGGESTION
: Add a retainer ring to keep the Dzus fastener to the Door.
RIVETING
the Dzus Spring: standard A4 with domed head on riveted: the beveled edged of
the wing longer door make countersinking unnecessary.
-end-
3/31/98: jigged6 / HDS-WING.doc
