Zenith ZLS4481W, Инструкция по эксплуатации

Страница: 13 / 23

EN
13
Reversing the door
Follow the step by step instructions
and the diagram below. Numbers in
brackets refer to diagrams.
1.
Switch off at the socket outlet
and pull out the mains plug.
2.
Remove all food, loose items
and fittings from inside the appliance
and door shelves.
3.
Carefully tilt the appliance
on its back side. (1) (You may need
somebody to help you.) Take care not
to damage the appliance by laying
on some protective material (e.g. its
original packaging). Make sure that
you tilt the appliance on its back
side, do not lay on it's side otherwise
compressor oil may block the pipes
and you may damage the appliance.
4.
Unscrew and remove the LHS
front feet and bolt (2).
5.
Unscrew the bolts and remove
the bottom hinge while holding the
door (3).
6.
Remove the door carefully from
the top hinge by sliding down wards
(4).
7.
Reposition top hinge bushing
and blanking plug on the opposite
side and stand the door safely (5).
You may find it easier to remove the
bushing and the plug with the tip of
a small screwdriver. Take care not to
mark the door.
8.
Reposition the top hinge on the
opposite side (6 and 7).
9.
To refit the door, locate the
top hinge in the door, attach to the
cabinet and hold the door (8).
10.
Fit the bottom hinge (9). If
necessary adjust and then tighten
the bolts. Ensure,that the door opens
and closes easily and that there are
no gaps allowing air into the cabinet.
If there are gaps between the door
seal and the cabinet, adjust the door
seal by gently pulling away from the
door using fingers.
11.
Fit the other front feet (10).
12.
Carefully stand your appliance.
(You may need somebody to help
you.) Adjust the front feet (See
Installation Instructions)
13.
Put back all, loose items and
fittings.
14.
Wait for at least 4 hours to
allow the system to settle before
switching on.