12
Installation
Cable
Cable
TV Setup
TV Setup
VCR Setup
VCR Setup
Connection 1
1. Connect the coaxial cable output on the cable box to the antenna input on
the TV.
2. Connect the coaxial cable from the wall to the input on the cable box.
3. Set the channel switch to 3 or 4 and then tune TV to the same channel
number.
Connection
2
1. Connect your cable input of the cable box.
2. Connect the audio/video output jacks on the cable box to the
corresponding input jacks on the TV, match the jack colors (Video = yellow,
Audio Left = white, and Audio Right = red).
3. Use the
tv/video
button on the remote control to select
Video
.
If connected to
S-VIDEO
on side panel, select the
S-Video
external input
source.
Important Note:
If your cable box has Component Video outputs or DVI, it is
recommend you use those connections for the best quality picture.
High Definiton input on this LCD TV is only supported on these two
connections. When using DVI there are three connections to each device,
the DVI cable plus the two audio cables. When using Component there are
five connections to each device, the red, green, and blue video cables plus
the red and white audio cables.
VIDEO IN
DVD/DTV IN
R
L
VIDEO
P
R
P
B
Y
AUDIO
(MONO)
H/P
+
75
Ω
ANT IN
S-VIDEO
AC INPUT
PC
SOUND
PC INPUT
COMPONENT(480i/480p/720p/1080i)
OUT
IN
CH3
CH4
S-VIDEO
ANT IN
ANT OUT
(R)
(L)
AUDIO
VIDEO
1
Typical
Antennas
VCR
Direct
Connection
2
- If your cable service does not require a converter box, refer to the Antenna Connection instructions.
- After subscribing to a local cable TV service and installing a converter, you can watch cable TV programming.
- For further cable TV information, contact a local cable service provider.
1
Cable Box
2
External Equipment Connections Continued
External Equipment Connections Continued
NOTE
In Video mode, TV automatically reverts to TV mode if the
fcr
button or
flashbk
buttons are pressed.
- A VCR can be setup in two different ways. The most common
connection is
Connection 1
but requires the TV to be tuned to channel
3 or 4 to view input from the VCR.
Connection 1
1. Connect the coaxial cable output on the VCR to the antenna input on
the TV.
2. Connect the coaxial cable from the wall to the input on the VCR.
3. Set VCR switch to 3 or 4 and then tune TV to the same channel
number.
Connection
2
1. Connect your cable and/or antenna connection to the input(s) of the
VCR.
2. Connect the audio/video output jacks on the VCR to the
corresponding input jacks on the TV, match the jack colors (Video =
yellow, Audio Left = white, and Audio Right = red).
3. Insert a video tape into the VCR and press PLAY on the VCR.
4. Use the
tv/video
button on the remote control to select
Video
.
If connected to
S-VIDEO
on side panel, select the
S-Video
external
input source.)
