Zenith Therm-X Series, Руководство пользователя

Страница: 14 / 38

13
IFU-001 Rev. 8
Customizing a Cycle
If a cycle other than a Quick Pick or Favorite is desired, you will be able
to customize a cycle from the “Custom” button on the Select
Treatment Program screen. (Please note: Custom cycles are single-use
only. If you would like to retain your custom cycle for future use, please see the “Quick Pick s and
Favorites” section.)
Once the “Custom” butt on is chosen, you will navigate to the ‘ Select Temperature ’ screen. “Custom”
will allow a choice from the range of either 34°-55°F or 105-110°F, unless the cycle chosen will be
Continuous, which will alternate between active and resting treatment continuously until the Stop
icon or Pause icon is pressed. The temperature range available for Continuous treatment is more
conservative; 40°-55°F for cold, and 105°-107°F for warm therapy. For more information, see the
“Continuous Treatment” section on page 16 .
After the temperature in the custom cycle is chosen, the Therm-X will prompt you to select a pressure
value on the
‘ Select Compression Level ’ screen. There are four levels of compression available to
select, as well as a toggle button to select either constant or intermittent compression. There is also a
“Back” button to return to the ‘ Select Temperature ’ screen. The compression range available for
Continuous treatment is more conservative; High pressure is not available.
After the compression level is chosen, the Therm-X will prompt you to select a cycle length value on
the
‘ Select Cycle Length ’ screen. You may select either of the preset times, create a custom duration,
or access the continuous option. There will also be a “Back” button to return to the ‘ Select
Compression Level ’ screen.
After the cycle length cycle is made, a complete cycle will have been created. On the ‘ Finish 1
st
Programmed Cycle ’ Screen you will then have options to “Add 2nd Cycle”, “Add DVT”, “Confirm” to
return to the ‘ Home ’ screen and store the cycle, or “Back” to return to the ‘ Select Cycle Length ’ screen.
At this point it is possible to use the “Add 2nd
Treatment” or “Add DVT” options if they are
accessible. The icons will appear grey (inaccessible)
if the cycle is set to Continuous. Please refer to
pages
12-13 for itemized instructions.