595-5507-10
-3-
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any
jumpers on your chime and push button.
WARNING: Disconnect chime unit from power source be-
fore opening code access door. Close door and replace
screw before reconnecting to power.
The push button and chime communicate by using a code that
can be changed by removing and/or adding jumpers on both
the push button and chime. The code is factory set; however,
there are 128 selectable codes that allow you to expand your
system and prevent outside interference. Other wireless prod-
ucts may cause interference and the system may not function
properly. Follow the instructions below for setting a new code.
1. Unplug wireless chime (if applicable).
2. Open the cases and locate the jumpers on both the push but-
ton and chime (See illustration on page 5).
3. The push button and chime both have eight different jumper
locations. The jumper positions 1 through 7 are used for set-
ting the code.
4. To change the code, add and/or remove jumpers as needed.
It is recommended to only change one jumper at a time and
then check to see if system is functioning properly. Note: Jump-
ers in positions 1 through 7 must be exactly the same for both
the push button and chime for this system to function.
