Zenith P60W26 Series, Руководство по обслуживанию

Страница: 15 / 32

SERVICING
PV154 - 923-03493
15
P60W26 - SERVICING
0 BCUT 7
1 RCUT 7
2 R-GAIN 0
3 G-GAIN 0
4 B-GAIN 0
5 S CONTRAST 0
6 S BRIGHT 44
7 S-COL 7
8 S-TINT 7
9 S-SHARP 3
10 CTI-LEVEL 0
11 R-Y/R 6
12 G-Y/R 10
13 R-Y/B 9
14 G-Y/B 5
15 GAMMA 7
16 LTI-LEV 0
17 PRE/OVER 1
18 DC-TRAN 0
19 D-PIC 2
20 V-TC 1
21 H-WIDTH 3
22 D-COL 1
23 HD-TC 0
24 SHP-FO 1
CXA2101
SERVICE MENU
Service Menu Adjustments for Plasma Display
Once the Main Video Scan Converter module is installed,
the unit will power on as soon as A/C is applied. The
EEPROM data will be set to Factory default values.
The following charts and instructions will allow you to
set access the service menu and make any necessary
adjustments during the repair and installation of the
PDP.
Adjustments must be done in both NTSC/PC and
DTV Modes
If the unit will power on prior to the replacement of
this Module and the menus can be accessed it recom-
mended that the servicer access the service menu and
record the data from the original EEPROM.
The Service Remote, which is provided with the service
kit, must be used to access the service menu.
Equipment Needed
:
NTSC Pattern Generator
DTV Pattern Generator.
INITIAL SETTINGS
1. Press (POWER ON) key
2. Press (ADJ) key.
3. Scroll down to (OPTION) item.
4. Press right arrow to enter (OPTION) menu.
5. Scroll down to (REMOCON) item.
6. Use (RIGHT) and (LEFT) keys to change to ZENITH.
7. Press (ENTER) to lock changes in memory.
ADJUSTMENTS
1. The following menu can be accesed with the unit
off by pressing (POWER ON).
2. Press (ADJ) key.
3. Use the (UP and DOWN) keys to select the sub-menu
you wish too access.
4. Press the (RIGHT) adjust key to access the menu.
5. The (UP and DOWN) will again access the line item
you wish to adjust.
6. The (RIGHT and LEFT) keys will change the setting.
7. ENTER will record the new settings.
Option 1 2 3 4 5
System NTSC NTSC 3Sys 3Sys 3Sys
Remocon NEC Zenith NEC NEC NEC
Language Korean ENG Portugal Espanol ENG
50/60 60 60 60 60 60
1 ADJ
2 W/B
3 CXA2101 ADJ
4 OPTION 2
HEAT RUN OFF
AUTO CUTOFF 1
R-CUT 22
G-CUT 11
B-CUT 23
R-GAIN 14
G-GAIN 13
B-GAIN 13
PHASE 30
H-PHASE 195
V-PHASE 34
EEPROM INIT