Zenith NA428, Руководство оператора

Страница: 17 / 48

14 Rev-5 Dec 2, 2019
BATTERY
The battery produces flammable and explosive hydrogen gas.
The battery electrolyte contains poisonous and corrosive
sulfuric acid. Review the safety precautions in "SAFETY
PRECAUTIONS - ELECTRICAL" before working on the battery.
Battery Specifications
Nominal Voltage: 12 V
Cranking Amps: 750
Cold Cranking Amps: 600
Ampere Hours 56
Battery voltage during alternator charging: 14.0 -15.0 V
Fully charged battery with key off @ 20 C (68 F): 12.5 -13.0 V
Half charged battery with key off @ 20 C (68 F): 12.0 - 12.5 V
Discharged battery with key off @ 20 C (68 F): less than 12.0 V
Battery electrolyte inspection
1.
Check electrolyte level.
2.
If low, top off with distilled water. Do not overfill.
Battery corrosion inspection
1.
Check battery posts and clamps for corrosion.
2.
If corroded, remove negative cable first, then positive.
3.
Clean both posts and both clamps with a small wire brush.
4.
Reconnect cables, positive cable first.
If the engine is cranking slowly or not at all:
1. Remove the battery negative lead from the battery.
2. Remove the positive lead from the battery.
3. Clean the battery posts and cables with a small wire brush.
4. Replace leads, positive lead first.
If the engine is still cranking slowly or not at all:
1. Remove the battery negative leads.
2. Recharge the battery in a well-ventilated area.
3. Reinstall the battery.
If the engine is still cranking slowly or not at all:
Replace the battery.