4
805757NZ v1.06 07.21 Miniboil Install Instructions
WARNINGS AND PRECAUTIONS
!
For continued safety of this appliance it must be installed, operated
and maintained in accordance with the manufacturer’s instructions.
This appliance may deliver water at high temperature. Refer to the
Plumbing Code of Australia (PCA), local requirements and installation
instructions to determine if additional delivery temperature control is
required.
• All plumbing must comply with AS3500.4.1 & AS3500.4.2
• All electrical must comply with AS3300 wiring rules
Safety
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety. Children should be supervised to ensure they do not
play with the appliance
Qualifications
If any power cord or plug is damaged it must be repaired only by a
qualified technician. To avoid hazards, all installation procedures
must be carried out by a suitably qualified trades person. The power
cord and general power outlet must be in a safe visible position for
connection.
Venting
Sometimes steam and / or boiling water may discharge through a vent
outlet at the mouth of the tap. If the tap is not installed using the Font
pedestal, ensure the tap body is located so the tap outlet safely drains
into the sink bowl area.
Lifting
Take care when lifting the Command Centre. Some units may
exceed safe lifting limits. Do not lift without assistance. The weights
of the units are given in the table under the heading “Installation
Requirements”.
Airflow
The ambient temperatures this unit should operate within are 5ºC
- 35ºC. The system will operate satisfactorily only if the recommended
air gaps are provided, as noted in the installation procedure.
Intended use
This appliance is intended to be used in household and similar
applications such as: staff kitchen areas in shops, offices and other
working environments; by clients in hotels, motels and other
residential-type environments; catering and similar non-retail
applications.
Frost protection
If this appliance is located where the ambient air temperature could
fall below 5ºC, do not turn off the appliance electrically. This safeguard
does not offer the same protection to the connecting pipework and
fittings.
The power point must be
located within reach of its
cable. The appliance must be
positioned so that the plug is
accessible.
This way up
Zenith Miniboil Command
Centre.
The appliance must be
placed on a horizontal
surface in an upright
position, as shown above.
