Zenith IQD61W35, Руководство по эксплуатации

Страница: 46 / 60

P A G E 4 6
206-03714
Programming the Remote
Test your remote control
To find out whether your remote control can
operate component without programming,
turn on the component such as the VCR and
press the corresponding mode button (VCR)
on the remote control while pointing at the
component. Test the
POWER and CH +/-
buttons to see if the component responds
properly. If not, it requires programming.
Turn on the component to be programmed.
Then press the corresponding mode button
on the remote control.
Press the POWER button and the MUTE but-
ton simultaneously. Then the remote control
is ready to program the code for the corre-
sponding component.
There are two ways to find the right code of
the component.
First, if you press the CH +/- buttons
repeatedly, the code will change one at a
time. Press the POWER button after each
code change. If the right code is found, the
device will turn off.
Second, enter the code number using the
digit buttons on the remote. The right code
numbers for the corresponding component
can be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the program.
Test the remote control functions if the
component responds properly. If not, repeat
from step 2.
1
1 2 3
4 5 6
7 8 9
0
tv
mode light power
antenna
video front
comp
rgb
vcr cable dvd sat
mute
timer freeze flashbk pip
menu
record stop
pause rew
play ff
exit
cc
surf
info
vol
ch
pg up
ratio
pg dn
digital eye
skip
enter
2
3
5
4
3
2
3
4
5
6
4
The remote control of your HD receiver is a multi-
brand or universal remote control that can be
programmed to control most remote-controllable
components of other manufacturers.
Note that the remote control may not control all
models of other brands.