803341NZ - HydroTap Taps Install Instructions 09.18 v2.11
Page 15 of 24
Mains
braided hose positions
RED: Hot IN from
hot water system
BLUE
Mains IN
4.3
Installation Instructions - Classic All-In-One Tap
Vented
silicon tube positions
Mains
silicon tube positions
Insert Silicon Tubes through Clamp Block
(viewed from underneath)
BLUE mark
WHITE mark
BLUE mark
RED mark
R
SILICON TUBES
USB CABLE
R
C
B
C
B
Working from inside the cupboard, screw the braided hoses to the extension tubes. Ensure the seals on
the end of the hoses are lubricated prior to assembly.
Check the correct position for Hot and Cold connections by matching the colours on the braided hoses
with the coloured markings on the copper extension tubes and on the clamp block (as indicated). Make
sure all tubes and hoses are firmly secured.
Test for leaks after all the connections have been secured.
Vented
braided hose positions
4.4
Affix Braided Hoses through Clamp Block
(viewed from underneath)
BLUE to HydroTap
Mixer IN
WHITE
Mains IN
RED from HydroTap
Mixer OUT
Thread the USB cable and silicon tubes through the circular clamp block. Check the tube colour alignment
with the diagram below.
Clamp the assembly in position using the threaded fixing nut (see fig. 4.5).