INSTALLATION GUIDE
Designer Slide Showers
Fit the cover buttons back onto the mounting
brackets, taking care to match the lug on the cover
to the notch in the bracket.
1
2
3
4
Slide Rail Installation
Carefully remove cover buttons from the mounting
brackets with a screwdriver as shown.
Fit the soap dish and slider onto the rail, sliding down
from the top of the rail as shown.
Select a location for the slide rail which is easily
reached and convenient for the user(s), preferably
over a wall stud or nog.
Using a level and the rail as a guide, mark and pre-drill
top and bottom mounting holes.
(If installing into wallboard or concrete, use toggles
provided by pre-drilling both top and bottom mounting
holes to 9.5mm diameter. Squeeze to close each
toggle and push in until flush with the wall).
5
Insert the screws provided through the mounting
brackets and into the pre-drilled holes. Tighten the
screws until the rail is firm against the wall.
