Zenith DTV1080, Руководство по эксплуатации и гарантия

Страница: 20 / 103

19
206-3675
3-1. Unpacking
HD satellite receiver
The Zenith HD Satellite Receiver is capable of receiving signals from the satellite dish, cable, and/or over-
the-air antenna and sending the decoder signals into your TV.
Remote Control
In addition to the Zenith HD Satellite Receiver, the remote control can be programmed to control many
other Zenith and non-Zenith devices.
Batteries
To install the batteries, slide open the battery compartment and insert the two AA batteries provided.
S-Video Jack and Cable
An S-Video jack is provided on the HD satellite receiver and is used together with audio cables. Remember
to connect the left and right audio cables. An S-Video jack carries only the picture signals, not the sound.
Audio/Video Jacks and Cables
The Audio/Video jacks provide excellent picture and sound quality. They are used for making most
Audio/Video connections between components. The Audio/Video jacks may be color coded (yellow for
video, red for right audio, and white for left audio). If your component has only one input for audio (mono),
connect it to the left (white L/mono) audio jack on the HD satellite receiver.
RF (Radio Frequency) Jacks and Coaxial Cables (F-type)
RF jacks are necessary for reception of over-the-air broadcasts, cable, and DIRECTV signals. These jacks
are also required for antenna or cable connections. The RF and coaxial jacks on the HD satellite receiver
are labeled Antenna, Cable, Satellite and OUT TO TV. An RG-6 type coaxial cable is required for satellite
signal distribution.
Digital Audio Out Jacks and Cables
The optical cable and coaxial cable are used for connecting a Dolby Digital receiver. If you own a Dolby
Digital receiver that uses an optical cable input, use an optical cable to connect the HD satellite receiver
to that receiver.
Telephone Jack and Cord
The telephone line cord is required to connect your HD satellite receiver to a phone line. If you choose to
subscribe to DIRECTV

programming, this phone line is required to be connected.
Component Out Jacks and Cables
Component Cables are used to connect your HD satellite receiver to an industry standard Y PB PR compat-
ible HD Monitor. A VGA cable can be also used to connect the HD satellite receiver to an industry-stan-
dard RGB-compatible monitor Via the HD Monitor Out jack (not included in this package).