D52WLCD
34
DISASSEMBLY
DISASSEMBLY
DISASSEMBLY
LAMP REPLACEMENT
WHEN TO REPLACE THE LAMP
¯ The projector image gets darker or starts to dete-
riorate.
¯ The lamp indicator is red (red, flashing alternately).
¯ The message “LAMP REPLACE” appears on the screen
when turning the projector on.
REPLACING THE LAMP
1. Turn the projector off and unplug the power cable.
(Let the lamp cool for more than 1 hour.)
2. Remove the four retaing screws on the lamp cover
and remove the lamp cover.
3. Remove the two retaing screws on the lamp case
(refer to fig 2).
4. Lift the wire handle of the lamp (refer to fig 3).
5. Pull out the handle slowly and remove the lamp
case.
6. Insert the new lamp gently into the correct posi-
tion. Make sure it is inserted correctly.
7. Tighten the two retaing screws on the lamp case.
8. Replace the lamp cover and tighten the cover
screws. (Make sure the lamp cover is securely fas-
tened. If lamp cover is open, the lamp indicator
flashes green and the projector will not turn on.)
RESETTING THE LAMP TIME
Reset the lamp time to zero by pressing the “?” key on
the remote control while in Stand-By mode. Then press
“9”, “8”, “7”, “6”, and the “OK” button. The three LEDs
in the front will flash for a moment.
LAMP LIFE TIME CONFIRMATION
Using the customer’s remote control, press and hold
the menu button. When the OSD menu disappears, press
numbers 9, 8, 7, 6 and press the OK button to enter
the ADJ mode. The display will show “Lamp Life Time
XX Hrs”.
< F ig . 1 >
< F ig . 2 >
Содержание D52WLCD Series
