05
806143NZ v1.06 07.19 CW ChillTap UCCT
Tap installation
In addition to common tools, the following will be required:
• 25mm (ChillTap Standard/Heavy Duty) OR 35mm (ChillTap
Extra) diameter sheet metal hole punch for sink tops (not
supplied)
• 25mm (ChillTap Standard/Heavy Duty) OR 35mm (ChillTap
Extra) diameter hole saw for timber bench tops (not
supplied)
Position the Tap
Warning: Do not reuse old hose-sets. The unit shall be
installed with the new hose-sets supplied. Hoses are
maximum 1000 mm in length.
Position and install the tap at the back of the sink or on the Font,
where there is a minimum 52 mm wide flat area within the draining
area of the sink. Make sure the selected position allows the tap
spout to overhang the sink bowl.
Ensure the distance between the tap and the command centre
does not exceed the length of the supplied tubing.
ChillTap Standard/Heavy Duty (Fig.1)
Use a 25mm sheet metal punch or hole saw to create a neat hole
without burrs.
Remove the large nut from the base of the tap, leaving the rubber
sealing ring (O-ring) in place.
Fit the tap and O-ring to the sink top, oriented so the operating
lever is easily accessible.
From under the sink, slide the nut over the tubes. Tighten the nut
to secure the tap firmly into place.
ChillTap Extra (Fig.2)
Use a 35mm sheet metal punch or hole saw to create a neat hole
without burrs.
Remove the large nut with the stainless steel and rubber washers
from the base of the tap, leaving the rubber sealing ring (O-ring) in
place.
Fit the tap and O-ring to the sink top, oriented so the operating
levers are easily accessible.
From under the sink, slide first the rubber washer, and then the
brass washer, followed by the nut, over the tubes. Tighten the nut
to secure the tap firmly into place.
O-RING
LOWER
RUBBER
WASHER
WASHER
NUT
Blue tube to
Chilled Outlet
Red tube to
Vent Outlet
White tube
to Ambient
Outlet
O-RING
White tube to
Chilled Outlet
Blue and Red
tubes to Tee piece
which connects
to Vent Outlet.
Fig.2 ChillTap Extra
Fig.1 ChillTap Standard / Heavy Duty
NUT
Installation instructions
