Page 8 of 24
804545NZ - BW_AB Small_09.18 v1.02
Fig.2
Depress
Inlet water
temp
15°C
10°C
3.0 Litre models 16 min 17 min
5.0 Litre models 16 min 17 min
7.5 Litre models 23 min 24 min
the vent outlet (i.e. the valve setting is correct). Water should not flow
into the tank.
3. Once the filter flush is complete, rotate the filter valve switch 180°
(either way) to point up to the “FILTERED” position (Fig.2).
4. Open the tap (push the lever backwards) into the locked open
position (Fig.2) and allow the tank to fill until water flows from the tap
outlet.
5. Once the water is available from the tap, turn off the mains water and
close the tap outlet.
6. Turn on the power to the unit (water must be in the tank).
7. Touch the white
circle next to the left of the
[Tick] to “Continue”
For screen operation, see the section on “Menu Operation”.
8. Boiling Calibration will commence. It will take several minutes for the
water to boil.
Calibrating Completed
9. When it completes (as prompted), turn on the mains water supply.
10. Select
to
Continue
11. The home screen will be shown (see section 2.1).
12. The tank will fill and heat. It will take the initial times shown in the
table to reach the final state.
Installation Procedures
Rotate switch to
FILTERED
FILTER FLUSH
FILTERED
