6
3. Extension cord.
When the work area is far away from the power source, use an extension cord of suf-
ficient thickness and rated capacity. The extension cord should be kept as short as prac-
ticable.
4. Temperature control
Before adjusting air temperature make sure the power switch is in the “Off” position. To
adjust press the switch and adjust air flow temperature by turning the temperature dial.
Maintenance anD inspection
2. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
WARNING
Repair, modification and check of ZENIT power tools should be performed only in
authorized service centers ZENIT. While use or maintenance of power tools follow all
safety rules and standards.
CAUTION
When using the screwdriver follow these rules:
•
continuous use of the power tool should not exceed 15 minutes;
•
do not allow mechanical damage (strikes, falls etc.);
•
protect the tool from external sources of heat and chemically active substances,
as well as liquid and objects penetration;
• before disconnecting the tool from the power source turn off the On/Off switch;
•
check the motor temperature, do not allow overheating;
•
change the rotation direction only after switching off the tool and complete
stop of rotating parts.
Inobservance of these rules will make warranty void!
NOTE
Zenit Power Tools are constantly being improved and modified to incorporate the latest
technological advancements.
Accordingly, some parts may be changed without prior notice.
