Zenit CS-508/2300-MK, Инструкция по эксплуатации

Страница: 9 / 14

9
2. Saw the felling cut from the other side of the tree 3-5 cm above the edge of the
notch.
3. Never saw completely through the trunk. Always leave a hinge.
• The hinge guides the tree. If the trunk is completely cut through, you lose control
over the felling direction.
4. Insert a wedge or a felling lever in the cut well before the tree becomes unstable
and starts to move. This will prevent guide bar from binding in the felling cut if you
misjudged the falling direction.
5. Make sure no people have come into the range of the falling tree before you push it
over.
6. Use wooden or plastic wedges to prevent guide bar from binding. Wedges also
control the felling direction.
Attention: If the cut is too close to the hinge, the tree should start to fall. When
the tree starts to fall, take the saw from the cut, turn it off and leave the site on the path
of retreat, controlling the felling direction.
7. Limbing.
• Do not cut limbs, standing on a trunk.
8. Cross cutting. Cross cutting is cutting a trunk of a fallen tree into logs.
• Take a firm stance.
• If possible the tree should have supports so that the ends to be cut do not lie on the
ground.
• If the log has supports from both sides, and the cut should be done in the middle,
make an upper cut to the middle of the log, and then make a lower cut. This will
prevent the guide bar from pinching.
• Avoid cutting into the ground.
• When cutting on a slope always take a higher position.
• If the log is supported from one side: first make a bottom cut about 1/3 of the log
diameter to avoid pinching. Then make an upper cut toward the lower cut.
• If the log has supports on both sides: first make an upper cut about 1/3 of the log
diameter to avoid pinching. Then make a bottom cut. The saw cuts should meet. Avoid
pinching.
8. MAINTENANCE
Attention: In order to avoid burns and fire danger do not perform maintenance
when the engine is still hot.
Proper and regular maintenance increases operating life and performance of the
chainsaw. User can perform only the maintenance described in the present manual.
Other types of maintenance and repair should be performed in specialized service
centers.
1. Every day before operation perform daily maintenance (see cl. 6.6.).
2. For maintenance and diagnosis we recommend contacting specialized service
centers at least once in six months.
3. Observe the following intervals