Zenit Powertools SEMI-PROFI ECS-406/2800 PROFI, Инструкция по эксплуатации

Страница: 6 / 10

6
Model ECS-406/2800 profi
Rated voltage 220-240 V
Rated frequency 50-60 Hz
Rated power 2800 W
Max chain speed 14.0 m/s
Bar size 406 mm
Gross/net weight 6.0/5.3 kg
Standard accessories list is subject to change without prior notice.
how to use
1. Filling oil tank
Never operate the chain saw without chain oil or at an empty oil tank level, as this will
result in damage to the product. Never use exhaust oil for lubrication. To fill the oil
tank disconnect the tool from the power source. Thoroughly clean the area around the
oil tank.
Unscrew the cap and put it aside.
Pour about 200 ml of oil and screw on oil filler cap. You can check the oil level
through a special oil-level gauge. If the chain is stored for a long period of time drain
the oil. Drain oil before transporting the chain saw or chain removal.
2. Chain and bus assembly
ATTENTION! always wear safety goggles and gloves. Disconnect the tool
from the power source.
To perform assembly use the supplied wrench. Perform following actions:
• unscrew fixing nut
• remove sprocket cover
• turn the adjusting screw to the left, till the boss reaches end of its travel
• install the saw chain in such a way so that cutting edges of the chain were facing
clockwise.
• the chain should stay on the bar and the boss of the chain tension should fit into the
whole of the bar
• install the case and fix it with screws. The saw chain is correctly tensioned when it
can be raised approx. 3-5 mm from the bar in the center finally tighten the fixing nut
with a wrench.
ATTENTION! in case of chain whipping or getting out of the groove in the bar
adjust tension immediately.
ATTENTION! before connecting the saw to the mains make sure that the