Zenit Powertools PROFI AG-180/2200, Инструкция по эксплуатации

Страница: 8 / 12

8
Disassembly
To remove the depressed center wheel, simply reverse the above-mentioned proce -
dure.
CAUTION
Tighten the wheel nut securely and confirm that the depressed center wheel does not
wobble.
Make sure that the push button is disengaged by pushing lock button two or three times
before turning on the grinder.
maintenance and inspection
1. Inspecting the depressed center wheel.
Confirm that there is no crack or any damage to the depressed center wheel.
2. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
3. Inspecting of carbon brushes
The motor employs carbon brushes which are consumable parts. Replace the carbon
brush with a new one when it becomes worn to its wear limit. Always keep carbon
brushes clean and ensure that they slide freely within the brush.
4. Replacing carbon brushes
Removal
Loose the screw retaining the brush cap.
Use auxiliary wrench or a small screwdriver to pull back the brush spring. Move the
spring edge from the brush holder.
Remove the brush pigtail from the brush holder terminal and remove the brush from the
brush holder.
Installing
- Install the brush pigtail in the brush holder terminal.
- Install the brush into the brush holder.
- Use auxiliary wrench or a small screwdriver to put the spring edge on the top of the
carbon brush,
- Install the cap and tighten the screw D4.
5. Maintenance of the motor
The motor unit winding is the very “heart” of the power tool. Exercise due care to un -
sure the winding does not become damaged and/or wet with oil or water.
CAUTION