2
3
CAUTION
● The DAB+ window mount antenna has been developed exclusively for use inside the vehicle.
● The antenna must not adveresly affect the driver’s field of vision.
● If your vehicle is equipped with a side airbag, the antenna must not interfere with the airbag functions in
any way.
● The antenna must not be installed on movable glass surfaces such as the side windows or rear window.
● Do not bend or damage the window mount antenna.
● The ZENEC system should be installed by an authorised specialist dealer.
Specific knowledge and tools are required for installation. Incorrect installation can damage the vehicle
and the ZENEC system.
● Plastic lever tool
● Optional: cross-head screwdriver (Phillips)
● Optional: flat-blade screwdriver
● Optional: Torx screwdriver (T20)
● Glass cleaner
● Cable ties
NOTE
● The strength of signal reception may be impaired if you install the antenna on infrared reflective glass,
thermal insulation glass, or on surfaces covered with reflective film.
● The signal strength also decreases if the antenna overlaps with another antenna, or if it is near a window
heating wire.
● If you have any questions or problems with the ZENEC system, please contact the retailer where you
purchased it.
TOOLS REQUIRED
No. Item
Quantity
1 Window Mount Antenna
1
SUPPLIED ITEMS
WORKING OUT THE INSTALLATION POSITION OF THE ANTENNA
Installing the antenna on the left-hand side
Installing the antenna on the right-hand side
(A) = Ceramic line (B) = Magnetic earthing strap
Installation:
1. Remove the A-pillar cover in your
vehicle. The cover is secured with
special clips.
A screw is usually concealed behind a
cover in the upper area of the A-pillar.
You can carefully prise the cover off
with a plastic wedge or a flat-head
screwdriver.
CAUTION
● If your vehicle is fitted with a side
airbag, you must leave the ignition
switched off for the duration of
the installation, and proceed with
extreme caution.
2. Clean the selected adhesive area on
the windscreen using the glass cleaner.
Wait until the glass surface has dried
completely.
3. Remove the protective film from the
window mount antenna (No. 1) and
attach it so it is flush with the ceramic
line.
Pay close attention to the installation
position of the antenna, which is
explained at the beginning of the
manual.
1
3
2
min. 150 mm
min. 150 mm
A
B
B
