Zenchef H01-1599A, Инструкция по эксплуатации

Страница: 16 / 47

How to Clean the Filter:
If you wish to clean the filter (17), you may remove
it by pulling vertically. To re-attach, simply line up
the filter(17) and press down to secure the filter
(Figure 8) .
1. Always make sure the Pressure Cooker is unplugged, depressurized and
completely cooled down before dismantling.
2. Use a non-abrasive sponge or damp wash cloth to clean the exterior of
the outer body (13) and the exterior surface of the pressure cooker.
NEVER immerse the pressure cooker in any liquids.
3. Remove the Condensation Cup (12) and rinse it thoroughly and let dry.
Clean the Upper Ring (9) with a damp sponge or wash cloth.
4. Clean the Lid (2) with warm soapy water, including the Rubber Seal Ring
(18), Pressure Limiting Valve (3), Filter (17), Vent, Float Valve (5) and let dry
thoroughly.
• The Pressure Limiting Valve (3) pops off easily by gently reaching
underneath it and gently prying upwards. Be careful not to damage the
thin wire spring under it.
• On the underside of the lid below the Pressure Limiting Valve (3), is a
small metal filter cap which can be removed easily to clean.
5. Let parts dry completely before reassembling.
6. Wash the Inner Pot (6) with a non-abrasive sponge and allow to air dry
or use a towel. It is not recommended to use any type of scouring pad that
can scratch the non-stick surface of the Inner Pot (6).
7. Clean the Pressure Limiting Valve(3)and the holes with a small brush to
ensure smooth flow of steam during the release cycle.
8. Store the inner pot inside of the Pressure Cooker. Store Pressure Cooker
in a cool, dry location.
15