•
Attach the other side frame, with the two pressure corners already connected, to the assembled frame. You
should now have a rectangle shaped floor with four fingers facing up.
•
Flip the screen over and insert the four pressure connectors into the frame of the enclosure.
Step 5
–
Door Assembly
•
Peel off brown paper lining of acrylic doors (Part L).
•
Attach the doorknobs (Part M) to the acrylic door panels using screws provided.
•
Insert top edge of either the right or left door into the back-top door rail and then align with the back bottom
door rail and drop into place.
•
Insert top edge of either the right or left door into the front top door rail and then align with the front bottom
door rail and drop into place.
Step 6
–
Wire Grommet
•
Insert plastic wire grommet (Part H-1) or solid plug (Part H-2) into the whole in the top of the back panel. The
smooth side of the grommet should face the inside of the habitat.
Step 7
–
Humidity Shield (optional)
•
Peel off brown paper lining of acrylic humidity shield (Part P).
•
Place on top of the screen. Be sure NOT to place heating elements on top of the humidity shield.
Step 8
–
Aluminum Door Wrap (optional)
•
Install first door in the back door track of your enclosure. The aluminum door wrap will be installed on the edge
of the door that faces the middle of the enclosure (opposite of the door handle).
•
Evenly apply the glue (Part R) into the channel of the aluminum door wrap (Part Q).
•
Align the bottom of the door wrap (channel side facing the edge of the door) towards the bottom of the door
first. Press the door wrap to the edge of the door evenly from bottom to top which allows the glue to adhere to
the doors.
•
Now install the front door and repeat the above process.
•
Allow the glue to dry before use.
