2. Move pump selection switch to “SINGLE ACTION” (easier) or
“DOUBLE ACTION” (faster)
3. Remove all air valve protective cap covers
4. Attach the Air Inflation Pump hose end to the air valve with a
clockwise twist
5. Use Air Inflation Pump to inflate each panel to 6 PSI (0.4 BAR)
6. After each wall of the Tank has been inflated make sure you fasten
the valve cap
a. Not doing this might cause air to leak if the valve pin is pushed
down
b. Move the string that connects the air valve protective cap to the
air valve body so it is not trapped under the air valve protective
cap
7. Place the Tank Body (#3) on the Drip Mat (#5) by lining up the Tank
Body over the Heating Pads (#4a & #4b)
8. Allow the Tank to sit for 24 hours as the panels may stretch, check
the panels after 24 hours and add pressure as needed
★
TIP:
Each valve has a pin in the center that can be manually pushed
down to quickly deflate the walls:
○ If you push down and turn the pin clockwise the airway will stay
open for easy deflation
○ When inflating a panel, check that the pin is in the proper UP
position to hold air
★
TIP:
This is the perfect time to reconsider the placement of the Tank -
get in and out, and move it around to be sure you’re happy with the
location before you add water and Epsom salt.
13
