![background image](http://html1.mh-extra.com/html/zelmer/zrf1450/zrf1450_user-manual_3335917012.webp)
Position the appliance away from:
- sources of heat (e.g. open flames, gas ovens, etc.)
- deposits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (minimum distance 2
metres)
fabrics (curtains, etc.) or loose materials, which may obstruct the ventilation grille; in addition, check that
the front part is free of volatile materials (dust, etc.).
The supporting surface must be stable, flat and even (so that the appliance does not tip over).
ASSEMBLY
Warning:
the fan may be used only if it is fully and properly assembled, that is to say, complete with the
base and the grille.
Warning:
always disconnect the appliance from the mains supply before assembling. If in doubt, have
the operation checked or carried out by a qualified technician.
ASSEMBLE OF BASE
Set the column in place on the base and secure it using the “L” screw with washer while also engaging
the counterweight.
Make sure column and base and counterweight are firmly coupled.
Loosen the Height Adjustment Collar on top of the Inner Tube. Pull the Inner Tube out from the Outer
Tube to adjust the tube to the desired height and tighten the collar.
If necessary, slightly loosen the Set Screw by turning it anticlockwise. Slide the Switch Box down over
the Inner Tube and tighten the Set Screw. Make sure the Set Screw is tightly secured.
ASSEMBLE OF BLADE AND GRILLE
Unscrew the plastic mounting nut from the front of the motor housing by rotating it anticlockwise.
Position the rear grille against the front of the motor housing with the handle uppermost, ensuing that the
locating pegs on the motor housing are engaged correctly in the holes of the rear grille.
Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin that
passes through the motor shaft.
Tighten the blade cap by turning it anticlockwise.
To fasten the front grill, it is best to place the main unit on a smooth even floor. Couple the front grill to
the rear and hold in place with plastic ring, (a fixing screw is good at the bottom) and secure fastening by
tightening screw
At the end of the operation, check that the protective grills are firmly coupled and attached to the motor.
USE
Before each use check that the appliance is in good condition and that the electric cable is not dam-
aged; if the electric cable is damaged, it must be replaced by the manufacturer or by the technical
assistance service or, in the event, by a qualified technician, in order to avoid any type of danger.
CONTROL PANEL
A. Power
B. SPEED button
C. MODE button
D. TIMER button
E. SWING button
F. Swing indicator
G. Speed indicators (high-mid-low)
12
EN
Содержание ZRF1450
