61
5500-003_v02
SAFBAG dust bag disassembly/assembly
G
1
The vacuum cleaner is equipped with safety valve located
in chamber of dust container (bag). It opens automatically in
case the total stopping of suction hose or total stopping of
equipment elements connected thereto happened, it opens
also in case the overfill of SAFBAG bag/dust container
„CYKLON” happened. One can hear characteristic „whirr”
sound inside the vacuum cleaner after opening the valve.
Opening the safety valve will cause turning on the lamp of
dust bag full indicator of dust bag/dust container „CYKLON”.
2
The light on dust bag/dust container „CYKLON”
(10)
full indicator (the sucker or the brush is upraised over the
cleaned surface) informs, that the bag is full and should be
therefore replaced with new one. Moreover, the dust bag/
dust container „CYKLON” full indicator may operate in case
of suction hose stopping or in case of stopping of equipment
elements connected thereto.
3
Switch off the vacuum cleaner by pressing the on/off
button
(7)
and unplug the appliance.
4
Press the two side buttons on the end of the hose and
remove the hose end from the inlet opening of the vacuum
cleaner.
5
Release the front cover fastening
(15)
and open the
cover.
6
Remove the SAFBAG dust bag module from the vacuum
cleaner chamber
(25)
.
7
Shut the SAFBAG bag cover in order to cover the hole of
the soiled bag. While holding the bag plate, bend it upwards
and pull the bag out of the bag catch, guides.
8
Insert the plate of the new dust bag in the tracks of the
SAFBAG dust bag module
(25)
and slide it until stop. The
direction for inserting the dust bag is indicated by the arrow
on the bag.
Slide the SAFBAG dust bag module together with the
●
installed bag in the tracks located on the side of the
vacuum cleaner chamber. Close the cover by pressing it
until you hear a characteristic click – pay attention not to
trap the dust bag.
Do not vacuum without SAFBAG bag module/
dust container „CYKLON” installed in the
vacuum cleaner. The lack of SAFBAG bag
module/dust container „CYKLON” disables
slamming the upper cover of the vacuum
cleaner.
ZELMER vacuum cleaners are equipped with SAFBAG dust
bags in the amount indicated in the table. It is recommended
to replace the dust bag if:
a) the dust bag full indicator lights up,
b) the safety valve activates,
c) the vacuum cleaner operates poorly,
d) the dust bag is full.
Dust container „CYKLON” disassembly/
assembly
The vacuum cleaner is equipped with removable dust
container „CYKLON” for collection of impurities. The dust
container „CYKLON” should be emptied when full.
Turn off the vacuum cleaner by pressing the on/off switch
●
(7)
.
Remove the connecting plug from power socket.
Press two side buttons placed on the end of hose, and
●
remove the hose end from the inlet of vacuum cleaner.
Release the front cover catch
●
(15)
and open it.
1
Put out the dust container „CYKLON” from the chamber
of vacuum cleaner.
2
Deflect the catches on the cover of dust container
„CYKLON” and open it until locked in the final position
(one can hear a characteristic “click”). Remove all collected
garbage from container.
When the above operation is completed, check
the basic filter HEPA and clean or replace it if
necessary.
3
Close the cover of dust container „CYKLON”, tighten the
lock strongly until you hear the characteristic sound („click”).
The container must be accurately closed.
Otherwise the dust will move to chamber of
vacuum cleaner, and the suction power will
decrease.
4
Put the empty dust container „CYKLON” into the chamber
of vacuum cleaner.
Close the cover by pressing it until you hear the
●
characteristic „click” sound.
Special accessories
The following special accessories may be purchased in retail
outlets:
Zelmer electrobrush (35)
Only the electrobrush manufactured by ZELMER may be
used with ZELMER vacuum cleaners. Using other brands of
electrobrushes may cause damage to the vacuum cleaner.
The electrobrush may be used with all ZELMER vacuum
cleaners equipped with the appropriate electrobrush socket.
While using the electrobrush follow the instruction manual.
The electrobrush is especially helpful in cleaning worn out
carpets. Before vacuuming remove all larger elements from
the floor such as: remains of cloth, paper etc. in order to
prevent blocking of the whirling element of the brush.
Zelmer turbobrush (34)
May be used with all types of ZELMER vacuum cleaners. Is
used for an effective vacuuming of carpets and fitted carpets.
While using the turbobrush follow the instruction manual.
The use of the turbobrush decidedly increases the
effectiveness of removing fibrous dirt such as: animal hair,
hair, threads etc. It is practically useful in households with
pets (cats, dogs), where removing the animal hair from the
carpets and floorings is very onerous.
H
Содержание Solaris Twix 5500.0 HQ
