Hardware Installation
!! MAKE SURE YOU CONNECT THE IR CONNECTIONS CORRECTLY !!
1.
Connect your HDM™I or DVI source (such as a Blu-ray Disc player) to the transmitting unit Z57BD2C [TX].
2.
Connect the IR blaster and receiver to the transmitting unit Z57BD2C [TX], and typically make the IR blaster directly
point to the IR sensor of the HDM™I source device(s).
3.
Connect your HDMI or DVI display (such as a LCD or plasma HDTV) to the receiving unit Z57BD2C [RX ].
4.
Connect the IR receiver and blaster to the receiving unit Z57BD2C [RX ], and typically make the IR receiver directly
point to the user.
5.
Connect two CAT5e/6 cables between the transmitting and receiving units via A/V SIGNAL and CTRL CHANNEL ports
respectively.
6.
Make sure your Cat-5/5e/6 cables are tightly connected and not loose.
7.
Plug in 5V DC power cord to the power jack of the receiving unit Z57BD2C [RX ].
8.
If you see flickering or blinking image on the display, try to adjust the rotary control switch to improve the
cable skew. 0 stands for the strongest HDMI™ signal level for longest possible transmission length while 7
stands for the weakest HDMI™ signal level for short transmission length. Try adjusting the signal level from 7
to 0 to find the optimal setting for the HDMI™ over CAT5 transmission.
~ 8 ~
