9
S
TEP
1
1
Place the DVS5.1 in standby mode by pressing the power button if
needed. At this point only the power indicator should be glowing
red.
S
TEP
2
2
On your remote control press the buttons in the following
sequence. After each button press verify that the remote IR
indicator flashes.
If you make a mistake, you can start over by
pressing
P
OWER
T
OGGLE
twice
.:
• P
OWER
T
OGGLE
• S
ELECT
I
N
+
• P
OWER
T
OGGLE
• S
ELECT
I
N
-
S
TEP
3
3
The DVS5.1 will power up indicating the new component codes
have been accepted.
Searching for a component code in your remote
Assuming you do not have a remote listed in this user manual you will have to follow your remote
control’s programming sequences to find a compatible component that the DVS5.1 understands.
Or you can also go to the section
"Learning New Remote Codes"
on page 10, to teach the DVS5.1
new keys for individual commands.
To search for compatible component codes you must place the DVS5.1 in standby mode and try
manufacturer codes in your remote control until one of them causes the DVS5.1’s IR indicator LED
to flash.
S
TEP
1
1
Place the DVS5.1 in standby mode by pressing the power button if
needed. At this point only the power indicator should be glowing
red.
S
TEP
2
2
Try different manufacturer codes until one of them causes the IR
indicator light on the DVS5.1 to blink when pressing the
P
OWER
T
OGGLE
key. When found, go to back to
"Using Alternate
Remote Codes"
on page 8, to teach the DVS5.1 to use the new
component code.
4
5
Audio
3
2
1
ZEKTOR
4
5
Audio
3
2
1
ZEKTOR
4
5
Audio
3
2
1
ZEKTOR
4
5
Audio
3
2
1
ZEKTOR
4
5
Audio
3
2
1
ZEKTOR
Содержание DVS5.1
Страница 1: ...ZEKTOR DVS5 1 DVI Video Audio Switch Owner s Manual www zektor com Rev 2 01 19 05 TM...
Страница 18: ...18...