Zektor DVS5.1, Руководство пользователя, Страница: 10 / 20

10
Learning New Remote Codes
Teaching the DVS5.1 to use learned remote control keys
If your remote does not have one of the pre-programmed component codes, or you simply want to
re-map the DVS5.1 functions to other keys on your remote, the DVS5.1 can be taught to use new
keys.
To teach the DVS5.1 to respond to new keys, you need to have the remote control you want to use
ready, and setup in the manner you want it to be used.
S
TEP
1
1 Place the DVS5.1 in standby mode by pressing the power button if
needed. At this point only the power indicator should be glowing
red.
S
TEP
2
2 Using a pen or pencil, press and HOLD the SETUP button on the
back panel of the DVS5.1 (located near the power jack) for around
4 seconds until the DVS5.1 powers up, and the Power indicator on
the front panel of the DVS5.1 will turn GREEN and begin to blink
RED.
The DVS5.1 is now ready to accept new remote control key codes. For
each of the following steps:
• You may press a key on your Remote Control. If accepted, the IR
indicator light will blink, and the key will be learned as the new key
for the given function. The DVS5.1 will advance to the next step.
• Or you may press and release the SETUP key on the back panel
of the DVS5.1. This indicates to the DVS5.1 to skip this key. The
code previously programmed for this key will be retained. The
DVS5.1 will advance to the next key.
• Or you may press and hold the SETUP key on the back panel un-
til the DVS5.1 returns to standby mode. This will end learn mode.
All keys already programmed will be remembered, and all the
keys skipped will retain their previously programmed values. The
DVS5.1 will advance to Step 13.
S
TEP
3
3 The Power indicator blinks slowly, and input 1 is selected.
Press the key on your remote that you want to use as the new key
for
S
ELECT
I
N
1
.
1
BLINK
4 5 Audio 3 2 1
ZEKTOR
4 5 Audio 3 2 1
ZEKTOR
4 5 Audio 3 2 1
ZEKTOR
4 5 Audio 3 2 1
ZEKTOR