Zeiss S88, Инструкция по эксплуатации

Страница: 97 / 182

G-30-1426-en S88 Floor Stand with Lifting Column Issue 9.0
Printed on 28. 01. 2009
Operation
97
Acoustic signals
Service display
In the event of an error, e.g. during the system check after power-on of
the suspension system, an error message appears in the control and dis-
play panel: a wrench symbol and an error code (XXX) are displayed and
three successive beeps are heard.
Inform the service department, telling them the error code and the serial
number of the system.
Motorized control of the surgical microscope is then no longer possible.
All microscope functions except recentering of the X-Y coupling can only
be operated manually.
However, you can still release the magnetic brakes using the appropriate
button on the left and right handgrips of the microscope.
When you press the "MANUAL" key, the surgical microscope can no
longer be operated via the foot control panel, the handgrips or the control
and display panel.
You can continue using the illumination system, but the lamp brightness
is automatically adjusted to a fixed setting. You can use the foot control
panel to switch the illumination system on and off.
Three succes-
sive beeps – Error message during software check after switch-
ing on the suspension system.
– Error message for an internal system error.
Single beep When the focus and zoom positions are stored.
Single beep Only with OPMI
®
VISU on the suspension system:
when brightness level 1.0 has been reached.
Single beep Only with OPMI
®
VISU on the suspension system:
after switching on the suspension system, if the lamp
brightness of one illumination system has been set to
level 1.0 or higher.
MODE STORE MANUAL
XXX