SM-30-0030-A02
Confidential and Proprietary
Service Instructions
Version 07, 2015-12-03
23 / 27
Order No. -
8
LED illumination unit
8.1
Changing the power supply board
1)
If a camera control unit is installed, loosen four
screws (
1
) and install the CCU again with two
screws like shown on the picture.
Fig. 41: Change the power supply board
2)
Pull flap (
2
) and remove the case lid (
3
).
3)
Disconnect the CCU cable from the PCB.
4)
Loosen two screws M 3 x 6 ISO 10644 and slide
off mounting bracket.
Fig. 42: Disconnect the CCU cable
5)
Unscrew four screws M 4 x 40 ISO 14583 (
4
)
and remove the side cover along with the CCU.
Fig. 43: Remove the side cover
1
2
3
4
