Zeiss OPMI Lumera i, Инструкция по эксплуатации

Страница: 72 / 184

Preparation for use OPMI Lumera i
Version 8.0
Page 72 G-30-1720-en
Connecting the light guide to the surgical microscope
Before using the system, check whether the light guide has been connected
to the surgical microscope. If this is not the case, connect the light guide to
the surgical microscope as follows:
• Switch off the illumination system.
• Insert the correct end of the light guide into light guide socket (2) of the
surgical microscope as far as it will go.
Always make sure before surgery that both the primary lamp and backup lamp
are intact.
Fig. 25: Connecting the
light guide
NOTE Risk of damage to the light guide!
• Please note the label under the light guide socket for the correct connection
of light guide (1).
• Make sure that light guide (1) is routed with sufficient slack so that it is
not stretched or bent when the microscope is turned or tilted.
1 2