Zeiss CL 6000 LED, Руководство по эксплуатации

Страница: 29 / 40

CL 6000 LED- | CL 9000 LED-Bedienungsanleitung
29 Stand Oktober 2015
4.3.2 Menu item „Memory“
In this menu item you can display and program the 6 memory slots individually. Also each memory stage can be switched off so
that it will not be called by pressing the rotary encoder (2).
The sub-menu „Memory“ is called by briefl y pressing the encoder (2). The top line of the display shows „**Memory**“, and the
bottom line of the display shows the respective memory slot Mem 1 - 6 with the corresponding intensity value.
By turning the rotary encoder (2), the intensity values of the memory slots Mem1 to Mem6 will be shown.
When the memory slots Mem1 to Mem6 are displayed, the „set M“ display for the respective memory slot can be called up and
accessed by briefl y pressing the rotary encoder (2). By turning the rotary encoder (2) the desired brightness value can be set
(level 0 ... 100) or by selecting „OFF“ it can be switched off. By briefl y pressing the rotary encoder (2), the selection is stored, and
you leave the submenu„
By turning the rotary encoder (2) in the submenu “Memory” you will access the subitem “Exit menu”. By pressing the rotary en-
coder (2) again briefl y you will leave the submenu “Memory”.
4.3 Menu navigation and LCD display
4.3.1 Set up menu
CL 6000 LED
Light: 33
Intensity has been set to a value (e.g. 33).
Rotate the incremental encoder (2) to change the intensity.
Press the incremental encoder (2) for at least 3 seconds to access the „setup menu“. The menu mode is
shown by the word „***Menu***“ in the top line of the display.
(Also applicable to CL 9000 LE
*** Menu ***
Memory >
Press for min. 3 seconds
*** Menu ***
Memory >
Press briefly
** Memory **
Mem1 0 _>
** Memory **
<Set M1 0
Press briefly
** Memory **
Mem2 20 _> ** Memory **
<Set M2 20
Press briefly
Turn
CL 6000 LED
Light: 20
Press briefly
Turn
** Memory **
< Exit Menu