START-UP
ZEISS
Mounting optional components
Axioscope 5/7/Vario
76
430035-7344-001
03/2018
NOTE
The reflective (coated) side (
3
)
of the color splitter has a tapered edge
(
1
) or corner (
2
).
•
Place the
excitation
part of the module
1
) on the
emission
part (
4
)
– holding the fixtures (
5b
) and eyelet
5a
) latches together. Hold both parts
together and turn them back into mounting
position.
•
Replace the slit screws and tighten them.
•
Finally, attach the label with the name of the
filter combination to the side of the module.
3.2.6
Mounting the polarizer D or the
filter holder
•
For easy assembly, remove the condenser carrier
(
3
) fully, with the stage carrier.
•
If necessary, unscrew stop bolt and bracket bolt
with low-power system from the condenser
carrier.
•
Hold the polarizer or filter holder (
6
)
parallel to the bottom of the condenser carrier
(
3
) and screw the bracket bolt
4
) of the polarizer (
6
) with
the angled adjustment lever (
5
) into
the front threaded opening at the left below
the condenser carrier (
3
) until it stops.
•
Screw the stop bolt (
2
) with the
adjustment lever (
1
) to the stop into
the rear threaded opening of the condenser
carrier (
3
).
NOTE
Proceed similarly when mounting the other components of polarization filter carrier.
Fig. 3-45
Labeling the color splitter
Fig. 3-46
Mounting the polarizer D