Zeiss Axio Zoom.V16, Руководство по эксплуатации

Страница: 28 / 66

SET-UP
Carl Zeiss Mounting the reflected light illumination Axio Zoom.V16
28 435080-9030-701 05/2012
3.8 Mounting the reflected light illumination
Depending on the application, different reflected light illumination units are used.
The required mounting faces are provided on the microscope.
3.8.1 Mounting on the objective (
∅
66 mm)
The following reflected light illumination units are mounted on the objective:
−
Fiber-optic ring illuminator (slit-ring illuminators)
−
LED ring illuminator
−
Diffusor S
•
Push the illuminating unit (Fig. 16/
3
) onto the
objective (Fig. 16/ 1 ) from below until it engages
and secure with the clamp screws (Fig. 16/
2
)
provided.
•
Insert the light guide input (Fig. 16/
4
) into the
light guide receptor (Fig. 16/ 5 ) of the cold light
source until it engages and secure with the
knurled ring.
Special ring illuminators are available
for easier handling on the nosepiece.
•
Insert the end sleeve of the light guide
(Fig. 17/
6 ) into the light guide receptor on the
upper side of the nosepiece (Fig. 17/
1
).
•
Insert the required light-conducting rod
(Fig. 17/
5
) onto the fiber input (Fig. 17/
4
) of the
slit-ring illuminator (Fig. 17/
3
) as required.
•
Fit the slit-ring illuminator onto the objective
from below, push it upwards until the fiber
input or light guide is fully inside the hole in the
nosepiece and secure with the knurled screw
(Fig. 17/
2 ).
•
Connect the light guide to the cold light source
(see above).
Fig. 16 Mounting the slit-ring illuminator
Fig. 17 Slit-ring illuminator with light-
conducting rod