![background image](http://html1.mh-extra.com/html/zeiss/axio-examiner/axio-examiner_operating-manual_3326798037.webp)
START-UP
Axio Examiner
Installing standard components
Carl Zeiss
M60-2-0003 e 05/2012
37
(2) Removing the stage carrier
Objectives are screwed in best and the condenser is inserted best when the stage carrier is removed. All
other assemblies installed like, e.g., the mechanical stage may remain at the stage carrier when this is
done.
Please proceed as follows:
•
Loosen the clamping rings (Figure 3-17/
4
).
•
Unscrew the screws (Figure 3-17/
7
), and remove the supports (Figure 3-17/
6
) from the stage carrier if
required.
•
Hold the stage carrier (Figure 3-17/
3
) in position with your left hand.
•
Loosen the clamping screw (Figure 3-17/
2
) by approx. 5 turns with your right hand.
•
Swivel the stage carrier horizontally to the left to slide it out of the dovetail guide (Figure 3-17/
1
) at
the right-hand side.
•
Then, remove the stage carrier from the stand by pulling it toward the front, and lay it down on the
table preventing it from overturning.
3.1.13
HAL 100 halogen lamp
Attaching the HAL 100 halogen
3.1.13.1
lamp
Before using the halogen lamp, the
exchange tool located inside the casing
needs to be removed because it might
be damaged by the heat effect
otherwise (cf., section 3.1.13.3).
•
Remove the transmitted-light socket cap
(Figure 3-18/
1
).
•
Insert the illuminator casing (Figure 3-18/
5
) with
the dovetail into the socket (Figure 3-18/
1
), and
secure it with the clamping screw
(Figure 3-18/
2
) using a ball head-screwdriver
(width A/F 3).
•
Connect the three-pole illuminator plug
(Figure 3-18/
4
) to the rear side of the external
power supply unit (Figure 3-18/
3
).
•
Connect the illumination control cable of the
external power supply unit (Figure 3-18/
3
) to
the stand.
Figure 3-18 Attaching the HAL 100 halogen
lamp
Содержание Axio Examiner
