Power Supply 12V 100W
SWITCHING ON SAFELY
ZEISS
09/2017
432610-6044-008
7
Englis
h
10
SWITCHING ON SAFELY
Operating elements of the Power Supply (front):
1
ON/OFF switch
2
Dimmer (potentiometer)
3
Pilot lamp for remote control operation
(external)
4
Reflected/transmitted light selector switch
•
Turn the Power Supply on by using the ON/OFF
switch (Fig. 3/
1
).
•
Switch on the microscope (see separate
operating manual).
11
HOW TO GET TO THE FIRST PICTURE
•
Turn the desired illumination system alternatively on/off using the reflected/transmitted light selector
switch (Fig. 3/
4
),
RL
position (reflected light) and
TL
(transmitted light), respectively.
•
Adjust the illumination intensity of the switched-on lamp by turning the dimmer knob (Fig. 3/
2
) of the
Power Supply.
Switching over between the illumination systems has no effect on the adjusted lamp brightness.
Therefore, the brightness must be readjusted after every switchover, if necessary.
•
If the microscope is connected to the Power Supply unit by means of the control cable (Fig. 2/
5
), the
dimmer of the Power Supply is inactive and the pilot lamp for remote control operation (
Extern
) is
lighting. In this case, the illumination intensity of the switched-on lamp is adjusted using the dimmer
of the microscope (e.g. adjusting wheel (Fig. 2/
4
) on the Axio Scope.A1).
12
SWITCHING OFF SAFELY
•
Turn the Power Supply off by using the ON/OFF switch (Fig. 3/
1
).
•
Switch off the microscope (see separate operating manual).
Fig. 3
Power Supply (front)
