Zeiss 15501-0101-000, Инструкция по эксплуатации

Страница: 8 / 282

2 Safety | 2.1 Intended Use ZEISS
2 Safety
This chapter contains general requirements for safe working practices. Any person using the Mi-
croscope or commissioned with installation or maintenance must read and observe these general
safety instructions. Knowledge of basic safety instructions and requirements is a precondition for
safe and fault-free operation. Operational safety of the supplied Microscope is only ensured if it is
operated according to its intended use.
If any work is associated with residual risks, this is mentioned in the relevant parts of this docu-
ment in a specific note. When components must be handled with special caution, they are
marked with a warning label. These warnings must always be observed.
2.1 Intended Use
The Primostar 1 is a microscope that has been especially designed for education and routine.
Typical applications include:
§
education (teaching, study)
§ laboratories
§ medical practices
Improper use can easily lead to impairment of its function or even damage to the Microscope.
Damage caused by incorrect operation, negligence or unauthorized intervention, in particular by
removing, modifying or replacing parts of the Microscope, can not be held liable by the manufac-
turer. Third-party devices or components that are not expressly approved by ZEISS may not be
used.
2.2 General Safety Information
This Instruction Manual must be read before commissioning in order to ensure safe and uninter-
rupted operation. Pay particular attention to all listed safety notes. Make sure, that
§ the operating personnel has read and understood this Instruction Manual, associated docu-
ments and particularly all safety regulations and instructions, and applies them.
§ the local and national safety and accident prevention regulations must be observed, as well as
the applicable laws and regulations in your country.
§ this Instruction Manual is always available with/together with the Microscope.
§ the Microscope is always in perfect condition.
§ the Microscope is secured against access by unauthorized persons.
§ maintenance and repair work, retrofitting, removal or replacement of components, as well as
any other intervention in the Microscope not described in this Instruction Manual, may only
be carried out by the manufacturer ZEISS or persons expressly authorized by ZEISS to do so.
2.2.1 Requirements for Operators
The Microscope, components and accessories may only be operated and maintained by autho-
rized and trained personnel. The Microscope may only be used in accordance this Instruction
Manual. If the Microscope is not used as described, the safety of the user may be impaired and/or
the Microscope may be damaged. Any unauthorized intervention or use other than within the
scope of the intended use shall void all rights to warranty claims. The regional regulations on
health protection and accident prevention must be observed at all times and during all work on
and with the Microscope.
Training Authorized ZEISS personnel will provide basic training in operating the Microscope. As well as in-
formation on equipment safety and maintenance work that can be conducted by the operator.
The training will be documented by ZEISS and its completion is to be confirmed by the operator.
8 Instruction Manual ZEISS Primostar 1 | en-US | Rev. 2 | 415501-7021-111