Zeiss 000000-1080-349, Инструкция по эксплуатации

Страница: 52 / 278

System Overview S100 / OPMI pico
Version 7.0
Page 52 G-30-1781-en
System overview
Surgical microscope The surgical microscope (4) enables the illumination and visual magnification
of the field of view. For visual magnification, the surgical microscope can be
equipped with different tubes, eyepieces and objective lenses.
S100 suspension system
The S100 comes as a floor stand, ceiling mount or wall mount. It is also avail-
able as a support unit and for adaptation to a Centro stand.
The S100 is used to control and supply the functions of the surgical micro-
scope. It consists of a carrier arm (2), suspension arm (3) and supply unit (1)
with light source. The suspension arm allows rough positioning of the surgical
microscope and moving into standby position.
The S100 floor stand can be positioned in the OR by four controllable
casters (5). The locking tabs of the casters prevent the system from being
moved or rolling away unintentionally.
Light source Depending on the order, the device may be equipped with a halogen, xenon
or LED light source. The halogen, xenon or LED light source is used to illumi-
nate the surgical area. It has a fiber illumination in the surgical microscope,
i. e. the light is directed from the light source via a light guide to the surgical
microscope. The halogen, xenon or LED light source is situated in the lamp
housing of the supply unit (1).
The halogen light source contains two halogen lamps. The second lamp is
used as backup lamp.
The xenon light source produces light whose spectrum is similar to daylight.
Regardless of the brightness setting, the color temperature of the light always
remains the same. Normal daylight film without any additional conversion fil-
ters can therefore be used for photographic documentation.
The xenon light source contains a lamp module with two xenon lamps. The
second lamp is used as backup lamp.
The LED light source has an integrated failure concept. In the event of a defect
in the LED light source, the light intensity drops to 50% and the control lamp
on the lamp housing lights up.