Concept House
Watchmoor Point
Camberley
Surrey GU15 3AD
Tel:
Fax: 01276 24058
[email protected]
www.zehnder.co.uk
Registered in England: 2296696
01276 605800
Zehnder Group UK Ltd
Issue 1.0
Key
Component
Qty
Tools & Material Required
Suitable valves
PTFE tape
Silicone thread sealant
Tape measure
Allen key - 13mm & 12mm (when installing Zehnder valves)
Electric drill
Masonry drill bit
Spirit level
Stepladder (for taller radiators)
A
Bracket Post
4
B
Spacer
4
C
Air Vent - 1/8”
1
D
Wall Plug
4
E
Bracket
4
F
Screw - 6mm dia x 50mm
4
G
Washer
4
H
Grub Screw
4
I
Allen Key
1
J
Air Vent Key
1
Assembly Instructions
Sufficient PTFE tape must be applied to valve-tail threads prior
to their installation.
Silicone thread sealant should be applied to all threaded
components manufactured with ‘O-rings’.
Screw bracket posts (A) & spacers (B) onto studs on the rear
of the radiator.
Fit valve tails, using correct size Allen key.
Fit air vent (C).
Accurately mark out bracket holes on wall using spirit level.
Drill four 8mm diameter holes to a minimum depth of 65mm
& insert wall plugs (D).
Screw brackets (E) into wall plugs (D) with screws (F) &
washers (G).
Slide bracket post (A) on radiator into bracket (E) and secure
in position by tightening grub screw (H) with allen key (I).
Plumb radiator to heating circuit with flow opposite air vent.
This radiator should be installed onto a central heating
system that has been cleaned/flushed and contains water
treatment and inhibitors in accordance with BS7593.
E
D
C
F
I
H
G
B
A
Zehnder Ovida Bow
