ZyPerUHD
Cleaning
Encoder, Decoder and ZyPerMP Unit Cleaning Procedures
Before cleaning:
1.Switch off or fully disconnect the AC power from the external supply unit
connector to the ZyPer unit.
2.If the state of the AC power cannot be established, disconnect the DC
input plug from the ZyPer unit before proceeding.
Cleaning Procedure:
1. Any unused cable receptacles should be covered with the supplied rubber plugs or a piece
of tape to prevent cleaner from entering and possibly affecting operation.
2. Clean the exterior of the unit with a soft cotton cloth that has been lightly moistened with an
approved and recognized cleaning agent.
The exterior of the unit has been tested for compatibility with, and resistance to, the
following products:
✦
Alcohol (Isopropyl and Ethyl)
✦
Ammonia-based cleaners (Windex)
In case none of the above cleaning products is available, water may be used.
User Manual
Page
of
18
29
