Page 4 of 8
www.zeevee.com
Ver.011513
Factory default settings in the product allow HDb2000 Series modulators to broadcast up to 4 HD sources on
RF channels 2 and 3, for reception at connected HDTVs.
1.
Apply AC power.
2.
Connect the Component (Red/Green/Blue) Video connectors on the AV Cable to the
corresponding Video Outputs on your video source. Use the Composite (Yellow) connector for
closed captioning.
3.
Connect either the Digital (Orange) or Analog (Red/White) Audio connectors on the AV Cable to
the Audio Outputs on your video source
4.
Connect the Coaxial Output of the HDb2000 to your
RF network.
CAUTION: The combined
RF output power for each channel is +45dBmV, which may overpower an HDTV if directly
connected. We recommend that you keep the power at each HDTV below +20dBmV.
5.
Set the RF input on the TV to Cable Mode (not Air or Antenna).
6.
Tune HDTVs to cable channels:
NOTE: Many TVs require a full
channel scan to find the channels.
HDb2000
RF A
RF Channel
2
HDb2000
RF B
RF Channel
3
AV Input 1
2.1
AV Input 3
3.1
AV Input 2
2.2
AV Input 4
3.2
Basic Installation
Coax cable connects
to coax network
Combiner
Other
+45dBmV
Sources
8:1 Splitters
Coax cables x6 to rest of Coax network
Coax cables x8 to HDTVs
HDTVs x8
Coax cables x8 to HDTVs
HDTVs x8
Back of HDbridge 2000 Series Modulator
WARNING: +45 dBmV
Do not connect directly to HDTV
RF Output
Audio /
Video Cable
Analog
Digital
Audio Out
Video Source
Composite
Video Out
Component
OR
f
or Close
d
Cap
tioning
