Zed Audio Kronos, Инструкция по эксплуатации и монтажу

Страница: 15 / 44

Specifications
Specification LEVIATHAN
KRONOS
Continuous Output Power into 2 ohm per channel 500wx2 250wx6
Continuous Output Power into 4 ohm per channel 250wx2 150wx6
Typical Output Power into 4 ohm per channel (1% THD) 290wx2 175wx6
Continuous Output Power 2 channels bridged into 4 ohm 1000wx1 500wx3
Continuous Output Power 2 channels bridged into 8 ohm 500wx1 300wx3
Minimum Speaker Impedance per channel 2 ohm 2 ohm
Minimum Speaker Impedance in Bridge Mode 4 ohm 4 ohm
Power Response at any power into 4 ohms/channel 10-30KHz -3dB 10-30KHz -3dB
Frequency Response at rated power into 4 ohms/channel 10Hz-25KHz -0.5dB 10-25KHz -0.5dB
Input Voltage range for rated power into 4 ohms 0.25-8.6 volt 0.25-8.6 volt
Input Impedance at 2KHz 37K ohm 37K ohm
Noise below rated output (30KHz limited) -101dB -98dB
Channel separation at 2KHz >80dB >80dB
Damping Factor at 20Hz with 4 ohms >80 >80
Total Harmonic Distortion with 4 ohm 20Hz-20KHz
From 1 watt to rated power. Typically less than 0.05%
<0.2% <0.2%
Intermodulation Distortion <0.2% <0.2%
Phase response at 20KHz Lagging 12 deg Lagging 12deg
Slew rate (volts per micro second)-In”Flat” mode 12 12
Low Pass Crossover (all are 24dB/octave) 46Hz-3.4KHz 80Hz-4KHz
40Hz-240Hz
High Pass Crossover (all are 24dB/octave) 46Hz-3.4KHz 80Hz-4KHz
Subsonic Crossover24dB/octave 11Hz-48Hz 11hz-48Hz
Equalization (Zero to +12dB variable control) Bass Boost @40Hz No
Line Output Yes No
Protection - Short Circuit, DC, Thermal Yes Yes
Power Source ----------10-14.5v DC Negative Ground -----------
Current Consumption with Sinewave at 4 ohms 50A 105A
Current Consumption with Music at 4 ohms 16A 30A
Idling Current <1.5A <2A
Fuse rating with 4 ohm load/channel 20A 20-25A
Fuse rating with 2 ohm load/channel **** 40A 60A
Size W x H (247mmx55mm/9.7”x2.1”) x L 272mm/10.7” 410mm/16.1”
Shipping Weight (Kg/Lbs) 5.9/13 6.8/15
**** Under normal operating conditions the fuse rating for 4 ohm loads will suffice for 2 ohm loads. If the amplifier is driven for long periods of time into
2 ohm loads per channel the fuse rating may be increased as shown.
++
++
++
++
++
++ Driving amplifiers with continuous sine wave power is very stressful and is not indicative of an
amplifier’s real world performance. We actually prefer to use PINK NOISE as our test signal as it very
closely replicates typical music which is what our amplifiers were intended for in the first place. Our
amplifiers will double the 4 ohm power at 2 ohm when driven with pink noise
DO NOT OVER FUSE ANY AMPLIFIER.
Page 13