6
7
C. Trainer system
- The Zebra 4 FM is equipped with a trainer system. (Slave mode only)
- Use trainer cord. (Not included) Include the part number of the trainer cord for this radio system
- When setting up the trainer system, make sure the student's transmitter is set up properly
so the trims and servo reversing are the same as the master.
- To activate the trainer system and transfer control to the student, pull and
hold the trainer switch located on the top left of the Master's transmitter.
Releasing the switch will restore immediate control back to the master.
- Trainer system is compatible with SIC (simulator interface cord- Part # 58318, not included)
designed to work with the popular and free FMS flight simulator.
(http://www.hitecrcd.com/product_fs.htm)
D. Range checking
- Always perform a range check before each operation.
- Perform range check by walking away from the aircraft with the transmitter antenna collapsed.
- You should have complete control from a distance of 60 - 90ft ( 20 - 30m ).
- If the controls are erratic before the minimum distance is reached,
do not fly until the problem is resolved.
3. Operation
Zebra 4 FM Instruction Manual
Zebra 4 FM Instruction Manual
BATTERY COVER
6 AA SIZE BATTERY.BE
CAREFUL TO LOAD RIGHT
DIRECTION OF BATTERIES (+ -)
+
+
+
+
+
+
B. Transmitter, Receiver and Servo Settings
Checking Operation of the Servo
After installation of the servo and receiver into your model is complete,
turn on the transmitter (fully extend the antenna) now turn on the receiver.
Check to see if all servos are working properly.
If not, check the connections and/or make sure that the main battery pack is charged.
If the servos check out is fine, connect the linkage to the servo horns.
Check that the servos are moving in the correct direction.
If not, change the servo direction with the reversing switches located on the bottom of the radio.
If everything is checked out, turn off the receiver first, and then turn off the transmitter.
Warning!!! : Do not shorten the length of the receiver antenna by cutting off any excess wire.
This will severely affect the operating range and could result in injury to yourself and others.
A. Installation of Receiver and Servos
After connecting the receiver and servos as below illustration,
turn on the power of the transmitter first then turn on the receiver.
(Always turn your transmitter first and off last to prevent lost of control.)
Now, move the controls to see if the servos are moving properly.
If not, check your wiring or crystals if the servos do not move at all.
RX Battery box
S/W HARNESS
Elevator Servo
Channel #2
Rudder Servo
Channel #4
Aileron Servo
Channel #1
Channel #3 for Throttle
7.2V-8.4V Batt.
ZR-106SF
Extra Long Range
FM
TO OPEN THE BATTERY COVER
OF THE ZEBRA 4 FM, YOU NEED TO
PRESS THIS AND PUSH IT DOWNWARD.