Zebex Z-6181, Руководство пользователя

Страница: 14 / 44

Dual-Laser Omnidirectional In-Counter Scanner 8
U
SER
’
S
M
ANUAL
If the scanner is connected to a keyboard wedge for this test, it should read
one barcode, beep, and the LED remain red. This is normal when the
keyboard wedge is not connected to a live host terminal.
The LED would flash red and read no barcode if the scanner is programmed
in USB interface but not connected to a host device.
If the scanner does not produce any beeps, or produces the wrong beeps, or
the LED is not lit up, remove the power connection and refer to the section
of Troubleshooting.
Connecting to the Host
The interface cable comes with different host-end connectors, depending on the host.
Follow the steps below to connect the device to the host.
1. Turn off the host system.
2. Connect the scanner and the host with the interface cable (Refer to your host
manual to locate the correct port for the scanner).
3. Plug the power cable to the jack on the device and connect the power cord to an
AC outlet.
4. If necessary, set up the scanner interface with the barcode in the programming
guide. (Refer to the Set Up section.)
5. Turn on the host system.
Interface Cable
Interface Types
The scanner communicates with the host through various types of interfaces. The
standard types of interface are:
(a) Keyboard wedge
(b) RS-232
(c) USB (supporting HID USB, virtual COM USB)
(d) IBM 468x/469x