21
Hoses
Your regulator was function tested and is ready for use from the factory. You
will need to install your high pressure gauge, instruments, and low pressure
accessories such as inflators. If you are in doubt on how to do this, see our
Zeagle professional retailer for assistance.
Low Pressure Hoses
(LP thread size 3/8"-24)
Your regulator has 5 low pressure (LP) ports in a fixed orientation. Choose
the ports that give you the best orientation for your particular set-up. The LP
port plugs can be removed by using a 3/16" hex wrench. Install the LP hoses
into the port, proper torque for the hose fittings is 40-45 in lbs. (4.5-5 N-m)
Do not over tighten as this will not improve the seal and may damage the
threads.
High Pressure Hoses
(HP thread size 7/16"-20)
Your regulator has 2 high pressure ports on either side of the body. The HP
ports and plugs are larger in size than the LP plugs. Remove the plugs with
the same hex wrench and install the high pressure gauge hose into the high
pressure port, proper torque for the hose fittings is 40-45 in lbs. (4.5-5 N-m).
System Set-Up
S
Y
ST
EM SETUP
