STEP 6: POWER AND CONNECT
1. Connect the Ethernet cable from the
Data
In
port on the PoE injector to your
network’s switch. Or, connect the PoE
injector to an AC power source.
2. Perform a spot-check to verify if the PWR
and LAN LED are lit to make sure the AP is
operating normally
2. Use a drill to drill a pilot hole at the
mounting hole locations you marked and
insert the plastic anchors.
3. Position the mounting bracket mounting
holes (with indents down) over the pilot
holes.
4. Insert a fastener into each mounting hole
and tighten.
5. Connect the Ethernet and power cables to
the access point.
2. Align the access point arrow print
△
with the one beside the cable access hole
on the mounting plate. When positioned
correctly, turn the AP clockwise until it
locks into place.
6. Connect the Ethernet and power cables to
the access point.
7. Attach the access point to the mounting
bracket.
6. Reinstall the ceiling tile.
MOUNTING ON A HARD CEILING OR A
WALL
This procedure describes the steps required to
mount the access point on a hard ceiling or a
wall using the universal mounting bracket.
1. Use the mounting bracket as a template to
mark the locations of the mounting holes
on the bracket.
