User Manual 3PH HYD5000-HYD20000-ZSS
Rev. 1.1 16/03/2021
Identification: MD-AL-GI-00
Rev. 1. of 16/03/2021 - Application: GID
21/138
3.6.
Assembly instructions
To remove the inverter, open the packaging, insert your hands into the slots on both sides of the
inverter and grasp the handles; lift the inverter out of the packaging and move it to the installation
position.
The inverter is quite heavy, so make sure to keep your balance while
moving it. Two or more people are needed to move the packaging and
inverter.
Danger
When placing the inverter on the floor, place foam or paper under it to
protect the housing.
Attention
1.
Determine the position of the holes, make sure the positions of the holes are level, then mark
them with a marker pen. Use the drill to make the holes on the wall. The drill must remain
perpendicular to the wall. Try not shake it while drilling the holes so as not to damage the wall. If
the holes are not level, they must be repositioned and drilled again.
2.
Insert the expansion screws vertically into the hole, making sure that the insertion depth is
neither too shallow nor too deep.
3.
Align the bracket with the hole, and secure it by tightening the expansion bolts with nuts.
4.
Position and fix the inverter to the rear panel.
5.
(OPTIONAL) install an anti-theft lock.
Figure 8 - Positioning of the inverter on the wall
