STEP 6: WATERPROFFING THE CABLE
For installation, you need to waterproof the LAN port
using the supplied sealing cap.
1. Slide the locking nut over the bare end of
the Ethernet cable.
2. Slide the sealing cap over the bare end of
the Ethernet cable.
3. Terminate the Ethernet cable with a
standard RJ-45 connector.
4. Connect the RJ-45 connector into the
wireless AP LAN port.
5. Flush the locking nut together into the
LAN port opening, then twist the locking
nut to seal the opening.
6. Tighten the sealing cap.
STEP 7: POWER AND CONNECT
1. Connect the Ethernet cable from the
Data In
port on the PoE injector to your network’s switch.
2. Connect the PoE injector to an AC power source.
3. Perform a spot-check to verify if the PWR and
LAN LED are lit to make sure the AP is operating
normally.
STEP 8: VERIFY THE CONNECTION
1. Use any wireless-enabled computer or mobile
device to search for and select the wireless
network you’ve previously configured.
2. If you can connect, open a browser and link to
any public Web site.
If you are using AP Controller to manage the AP,
please refer to the AP Controller user guide to
learn how to configure and manage the AP from
the AP Controller Web interface.
The latest versions of user manuals are available
for download on the ZDC website at:
www.zcom.com.cn
Copyright © 2015 Z-Com, Inc. All rights reserved.
ZDC is trademark of Z-Com, Inc. All other company
and product names mentioned in the documentation
are held to be trademarked (and registered) by the
primary holders.
