1. Gather Basic Information.
Gather the following information and
write it in the space provided for future
reference. Enter “NA” for not applicable.
Refer to end of this Guide for sample
configurations.
j. Password:__default_____________
k. ESSID:
_________________
l. IP
Address: _________________
m. Netmask:
_________________
n. Gateway:
_________________
o. Enable DHCP client:
YES ___ NO ___
p. Enable Internal Router:
YES ___ NO ___
q. Internal Router’s WAN Port on:
WLAN ____
Ethernet _____
r. NAT:
YES _______ NO_________
Internal Router’s LAN port IP address:
___________________
s. Internal Router’s LAN port Netmask:
___________________
t.
Enable Internal DHCP server:
YES ________ NO ______
Begin IP_________________
End IP__________________
Netmask________________
Gateway________________
Primary DNS_____________
Secondary DNS___________
Primary WINS ____________
Secondary WINS _________
WEP Key: _______________________
2. Install
Software.
Install the software on a PC connected to the
same Ethernet segment as the product.
a. Insert the CD into your CD-ROM
drive. Run SETUP.EXE from the
CD's root directory.
b. Follow the on-screen prompts to
install the software on to your
system.
3. Connect
All
Cables.
Connect cables as follows:
a. Insert the Category-5 cable to the
Power Injector port marked
"NETWORK". Insert the other end of
the cable to an Ethernet hub.
b. Insert the CPE-250HP's RJ-45
connector to the Power Injector port
marked "CPE".
c. Insert the AC adaptor connector to
the Power Injector port marked "DC
In". Insert the AC adaptor to a wall
AC outlet. The Power LED on the
CPE-250HP should turn on.
4. Configure
Product.
On a PC that is attached to the same
Ethernet segment as the CPE-250HP, run
the installed CPE-250 Manager software to
configure the product.
a. On the Windows desktop, click on
START|PROGRAMS|ZCOMAX CPE-250
MANAGER/CPE-250 MANAGER
to start
the software.
b. Once started, the CPE-250
Manager will browse the Ethernet
segment to locate any attached
CPE-250HP Series products. It will
display all CPE-250HP units that it
can locate during this discovery
process. Each CPE-250HP unit is
displayed in the form of an icon with
its default name listed below. This
default name is formed by
concatenating "AP" with the last 6
numbers of the CPE-250HP's MAC
address (example: AP123456).
I
NSTALLATION
