conjunction with any other transmitter or
antenna
Check Product Contents.
Check product for complete contents.
The following items should be
included in the box.
a. CPE-2(x) Series ( See
components of CPE)
b. AC Adaptor*
c. Power
Injector*
d. 6’ Category-5 Cable*
e. 5” Category-5 patch cable
f. Category 5 feed line 1-300’
g. Software
CD
h. This
Guide
i. Mast-mount
Hardware:
i. Brackets x 2
ii. Clamps x 2
iii. Screws x 4
iv. Washers x 8
v. Nuts x 4
WARNING:
Items “b”, “c” and “d” are
for indoor-use only.
Components of CPE:
o
Single board computer (SBC)
– The
SBC is a ARM PCMCIA Platform that
is used to interface with the RF PC Card.
It is used to control the PCMCIA
firmware as well as Convert all Ethernet
802.3 packets to wireless 802.11b, using
the PCMCIA Card.
o
Wireless RF card
– The PCMCIA card
is an 802.11b wireless radio module that
is used to transmit all data intended for
the link it is attached to.
o
Antenna
– The PCB panel antenna is
tuned for the 2.4 – 2.8 frequency range.
It comes in two sizes, 15dBi and an
18dBi. The antenna selection is used to
determine the out power needed to
establish a reliable connection.
Configuration:
Connections
o
The PCMCIA Card is inserted into SBC,
The PCMCIA rails are keyed so as to avert a
wrong insertion method.
o
The Antenna feed line is terminated with
an MMCX reverse polarity plug that is
used to connect to the PCMCIA’s
primary antenna jack (Jack closets to the
PCMCIA’s LEDs.
Mounting
o
The antenna can be mounted with the
use four predrilled mounting holes to
assure it will be firmly held in place
o
The SBC has four mounting holes that
are grounded to the main electrical
ground of the SBC.
o
The POE splitter has pre drilled
mounting holes that allow it to be firmly
held in place
Cable connections
o
The 6” Category 5 patch cable is used to
connect to the SBC’s ethernet jack and
the POE splitters Etherent jack.
o
The DC power cord is used to connect
the DC splitter board (main power feed)
to the SBC’s dc jack.
o
The main Ethernet feed line can now be
connected to the input Ethernet jack
located on the POE splitter and
connected to the DC injector box, once
in place the compression fitting cap can
be tightened.
o
The 6’ Category 5 patch cable can now
be connected to the main Ethernet
connector located on the desired device.
o
The device is now connected and ready
to go.
